Hampton Capillary Cutting Stone

Hampton Capillary Cutting Stone

APPLICATIONS

  • The easiest way to cut capillaries

FEATURES

  • Score and snap.
  • Ceramic cutting stone

DESCRIPTION

These small (25 mm x 25 mm x 0.65 mm) cutting stones are used to make clean cuts of glass and quartz capillaries. Use the edge of the stone to etch the capillary then gently snap the capillary in two. This is useful for cutting the tips off closed capillaries used for mounting single crystals for x-ray diffraction analysis or for cutting capillaries to the desired length.

Capillary Cutting Procedure

1. Gently place the capillary on a clean, flat surface.
2. Gently holding the stone at approximately 30° angle to the capillary tube, starting near one edge of the stone, proceeding in a single, smooth motion, draw the length of the non-serrated edge of the stone across the capillary one time . Apply just enough pressure to score the capillary, do not attempt to cut through the capillary.
3. Pull the capillary axially until it breaks. If it won’t break, the score was not deep enough. Repeat the above steps, pressing down with slightly more force while drawing the cleaving stone the capillary.
4. Once cut, inspect the end finish to ensure the cut quality meets the application requirements.

毛细管切割石材™

应用

  • 切毛细血管最简单的方法

特征

  • 分分秒秒。
  • 陶瓷切割石

描述

这些小切割石(25毫米x25毫米x 0.65毫米)被用来切割玻璃和石英毛细血管。用石头的边缘蚀刻毛细,然后轻轻地把毛细拧成两半。这是有用的切尖关闭关闭毛细管用于安装单晶x射线衍射分析或切割毛细血管到所需的长度。

毛细管切割程序

1.轻轻地将毛细放在干净、平坦的表面上。
2.以大约30°的角度轻轻握住毛细管,从石的边缘开始,以一次平滑的方式进行,一次画出石的非锯齿状边缘的长度。施加足够的压力来打分毛细血管,不要试图切断毛细血管。
3.轴向拉毛,直至毛细血管断裂。如果它不能打破,比分是不够深的。重复上面的步骤,用稍微大一点的力量按压下来,同时把切割的石头拉到毛细上。
4.切割后,检查成品,确保切割质量符合使用要求。

RELATED IT

HR4-334 Capillary Cutting Stone each、

EM(S)